|
The Safe Solution ALBA PLUS (+) Liquid Antibacterial Acid
ALBA PLUS is a new concept in water bore clean-out and maintenance. ALBA PLUS corrects problems
in water bores which have never been accomplished in the past with muriatic
acid, chlorine or sequestering agents combined or in series. ALBA PLUS controls iron
bacteria after each treatment. Chlorine
gives only surface sterilisation on iron bacteria but is unable to dissolve
iron bacteria encrustations. ALBA PLUS dissolves slime
and organic deposits of iron bacteria and holds them in solution until
they are pumped out. ALBA PLUS is recommended
for complete bore clean-out of iron bacteria. ALBA PLUS unites with
the oxide forms of iron and manganese to form soluble salts which are
held in solution until pumped out to waste.
Chlorine does not have the ability to perform this function, which
is referred to as chelating. Advantages of ALBA PLUS · Kills iron bacteria. ·
Dissolves iron bacteria encrustations,
organic deposits of iron bacteria, slime and hard water scale formed on
the screens. Sulphides and
metallic oxides are held in suspension until pumped out. ·
Eliminates water stains caused by iron
manganese oxides. ·
Generally increases water bore production. ·
Improves taste of water when made disagreeable
by bacteria. Safety of ALBA PLUS ·
ALBA Plus is a liquid, non-volatile,
organic acid used much in the same way as mineral acids for water bore
clean-out. Since there are
minimal toxic fumes, the product should be used in a well ventilated area. ·
ALBA PLUS is inhibited and when diluted
per our dosage table there is a minimal corrosive problem. ·
ALBA PLUS presents no fire or explosive
hazard. ·
Adequate flushing of the treated bore
will ensure that the residual acids or its salts will be reduced to a
safe level. ·
Boress cleaned with ALBA Plus show that
the rate of production fall-offs is decreased, thus requiring less frequent
cleaning. ·
ALBA Plus reduces the distribution system
clean-out cost when iron bacteria encrustation or slime has been a problem. ·
ALBA Plus can be added directly to the
bore ·
ALBA Plus can be used in areas which
are predominantly limestone. ·
ALBA Plus has excellent mud dispersing
qualities. ·
ALBA Plus reduces Operator hazard. Usage Procedure First,
the bore must be disconnected from the distribution system. ALBA Plus can be pumped or poured directly into the bore.
The pump and piping may be left in place.
Periodic surging with the pump during the treatment period of 12-24
hours is desirable. If the
pump and piping have been removed, bailing or swabbing intermittently
during the treatment period would be necessary. After
the treatment period the ALBA Plus can be pumped out to waste.
It is of greatest importance to pump and surge alternatively until
the water is clean. This
intermittent surging and pumping aids in the removal of undissolved scale.
Pumping to waste should be continued until the maximum difference
in pH of the water before and after treatment is .5pH units, and the hardness
has returned to its original condition, prior to treatment.
This assures complete removal of the residual acids and the dissolved
products. Recommended Dosage The quantity of ALBA Plus to be used can be determined from the dosage table. These amounts give a 5% or 10% solution when mixed with the static water in the bore, depending on the severity of the problem. Where iron bacteria reappears and complete suppression is mandatory, subsequent 1% treatments two or three times a year will do the job. The dosage for the 1% treatments would be one-fifth or one-tenth of the original treatment. Dosage Table
NB Table does not take into consideration voids in a gravel packed bore. If voids are known to exist, add up to 30% to the quantity shown on the Dosage Table. Packaging ALBA Plus is available in 20 litre or 200 litre drums.
|
|||||||||||||||||||||||||||||||||||||||